loading

Alien sanding machine to use?

by:Gewinn     2020-06-20
A lot of people ask different sanding machine to use? Clearly is useful. Below will tell everyone abnormity sanding machine operation process: a, sanding machine conveyor belt grinding sanding pad, workbench level adjust start sanding machine and conveyor belt litres of workbench, gently touch the abrasive belt to the workbench. Conveyor belt grinding amount no greater than zero. 1 mm to avoid conveyor belt hot deformation. After adjustment, removal of wear debris, thickness is set to zero second, adjust the workbench thicknessing roller grinding level, removing the sand take a piece of a set with a 60 - thick sanding surface 80#砂纸的模板放在输送带上,定厚辊下,模板宽度大于200mm   启动定厚辊电机,升起工作台,使砂纸轻轻触及辊子   沿钢棍长度方向来回移动模板,平稳、匀速、不停留   调整完毕,清除磨屑,厚度设定归零   三、压辊调整   升起砂光垫,卸去砂带   升起工作台,使定厚辊轻轻接触输送带,然后根据厚度显示读数将工作台下降1mm   松开螺母,内六方松压辊两端螺母,直到压辊轻轻接触输送带   拧紧螺母   四、砂垫校平   升起砂光垫,卸去砂带   将一小型水平尺放在输送带上,升起工作台,直到定厚辊与水平尺轻轻接触   将砂垫下降与水平尺轻轻接触,把平尺从砂垫的一段移到另一端,检查砂垫的水平度   如有误差,通过砂光垫左右螺纹调整   五、砂带摆动调整   由光电开关控制,调整其位置可以改变砂带摆动基准,一般离棍子边沿25px   砂带左右保护纤维由两对光电管控制,基准在棍子边沿,到此位置停机   六、显示调零   出厂前已经调零,在进行工作台平面度调整,输送带修磨、定厚辊修磨以后,必须对厚度数字显示归零   1. Thick sanding a piece of sample, measuring thickness, precisely to 0. 1毫米2。 Adjust the height of sensor, digital display and the measuring sample thickness consistent 3. Tighten the nut to check again after a digital display.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...