Automatic polishing machine general fault how should solve?

Automatic polishing machine fault common failures and troubleshooting methods 1: polishing wheel startup large noise elimination method: remove the polishing wheel in through the nose and let it idle alone to hear the noise. 1: check the nose of the belt is tight, if not close, must be adjusted, if there is this kind of phenomenon, communication maintenance shall be notified by the manufacturer; ( 2) : different polishing wheel, eccentric lead to large noise, troubleshooting methods: replace or repair after polishing wheel and polishing wheel, its installation and use. Fault 2: workpiece clamp instability analysis of the causes of failure of automatic polishing machine. ( 1) Loosen the spring screws under the jig troubleshooting methods: replace or adjust the spring screw, until completely clamping workpiece; ( 2) Clamping shell and the top of the core of conical surface sediment troubleshooting methods: use lifter cylinder lifting clamp clip, remove the sandwich core, clean up the sediment, push core after installation. Automatic polishing machine friendship tips on notice: 1, should first check before starting the disc or the equipment have not take the artifacts and other sundry; 2, automatic polishing machine during operation in exchange Labour should stay on a disk to stop, and must be installed before the next rotating disc; If found any abnormal noise while working or other abnormal phenomenon, should immediately press the stop button, stop check, to handle the exception can continue to work; 3, 3. Request equipment by trained and professional operation, notify manufacturer for communication and maintenance when necessary. That is automatic polishing machine fault solution, if necessary, direct consultation day super mechanical after-sale service for customer. Relevant tags: wood polishing machine, automatic polishing machine, sanding machine, wood sanding machine