Automatic polishing machine problem how to solve?

Automatic polishing machine fault common failures and troubleshooting methods 1: polishing wheel startup large noise elimination method: remove the polishing wheel in through the nose and let it idle alone to hear the noise. (1) : check the nose belt slack, is not tight must tighten it, such as the phenomenon still exists the communication need to inform the manufacturer maintenance; 2: different heart polishing wheel, eccentric, noise elimination method: to change polishing wheel after installation or repair of polishing wheel is concentric. Fault 2: workpiece clamp instability analysis of automatic polishing machine fault reason: ( A) Remove clamp under the spring screw loose or fall off, replace or adjust the spring screw until the workpiece clamping completely; ( 2) Fixture enclosure and the center cone and sediment troubleshooting methods: using the lifting cylinder jacking device, eliminating the jig center, clean up dirt accumulation, back into the center. Automatic polishing machine friendship tips on notice: 1, should first check before starting the disc or the equipment have not take the artifacts and other sundry; 2, automatic polishing machine during operation in exchange Labour should stay on a disk to stop, and must be installed before the next rotating disc; If found any abnormal noise while working or other abnormal phenomenon, should immediately press the stop button, stop check, to handle the exception can continue to work; 3, 3. Equipment should be operation by trained professionals. If necessary, manufacturer shall be notified to communication and maintenance.