Automatic polishing machine will encounter problems in use

Automatic polishing machine common failures and troubleshooting methods: failure 1: polishing wheel startup noisy trouble-shooting methods: get off the plane head polishing wheel, let it idle and listen to the noise 1: check whether the nose belt tightening. If not, it must be tight. If the phenomenon still exists, should inform the manufacturers to communicate and maintenance; 2: polishing wheel is not concentric, eccentric caused the noise, the troubleshooting method is: change the polishing wheel and polishing wheel or repair the concentric and installation. Fault 2: workholder instability analysis automatic polishing machine failure reason: 1 fixture screw loosening or loose loose at the bottom of the spring. Eliminate failures: replace or adjust the spring screw until completely clamping workpiece; 2 fixture on the shell and the top of the cone core mud methods: lift the jig using top cylinder, remove the sandwich, clean up the debris, replace the top core. Automatic polishing machine helpful hints to start note: 1, automatic polishing machine should check the machine before starting the workpiece on the disk or equipment and other sundry; 2, during the automatic polishing machine running fully automatic replacement artifacts, until the disc stops, and must be in the disc before the next rotation installation; If found abnormal noise in the process of operation or other abnormal phenomenon, please press the stop button immediately. , stop check, waiting to be processed, and then continue to work; 3, asked this equipment should be operated by trained professionals. If necessary, manufacturer shall be notified to communicate and maintenance.