Sanding machine operating instructions

1, sanding machine without professional training before, no one may open operation equipment. 2, such as sanding mechanism motion device expires, shall not be used again. 3, sorting machines and work site on a regular basis. 4, check the transfer station and the presence of obstacles between abrasive belt wheel, rooting out with compressed air blowing off. 5, check the sanlian pieces of oil mist of oil, put the filter in the water, air pressure should be no less than 0. 6Mpa。 6, check the conveyor belt drive reducer oil. 7, check the three 380 x 50 hz power supply is normal. 8, turn the power control switch, air and dust control valve is connected. 9, to check the belt tension. ( Tension pressure value usually at 0. 3Mpa～0. 5 mpa between adjustment) 。 Close door. 10, according to the request to the data input button set control panel. A sand machine, the machine will press successively program to start the job. 11, sanding machine operation height, can use this machine is equipped with active thicknessing machine adjust actively, and can be used the handwheel and fine-tuning of the abrasive belt wheel equipment harmony, its amount of sand cut should be recuperated from small to large step, prevent damage of the large amount of sand cut sand belt and sand roller. 12, according to the machining of the raw material, the thickness of the abrasive belt and feed speed of conveyor belt. Regulate feed speed, it is necessary in the motor, when working to stop after downtime scroll forced regulate the handwheel. 13, in the sand when the cut is less than 600 mm panel, secure the right and left sides of the conveyor belt in together, to prevent use of abrasive belt have gathered a certain period, improve the utilization rate of abrasive belt. 14, halfway to replace sand belt, it is necessary to close vacuum valve, and according to the motion of the abrasive belt direction arrow. Due to power outages in 15, homework, pressure on the abrasive belt wheel at the bottom of the workpiece to prevent forced out. 16, when there is other anomalies machine, it is necessary to stop the machine immediately to repair. 17, after the operation, control program closed and closed after the total motor power, air and vacuum valves. 18, with compressed air blowing off the conveyor belt and sand dust crumbs in the body. 19, insist on the machine and the surrounding clean. 20, every day to check the motor brake equipment. 21, adhere to the oil mist, and reducer oil is enough. 22, every three months to the axle hole filling butter. 23, check sander trachea, every valve, leakage is not allowed.