Surface profile sanding machine safety operation procedures

Surface profile sanding machine safety operation procedures: one, this machine must be specialist operations, prohibit others to operate the machine. First check before starting the: 1 voltage, air pressure is normal, 2 machines have sundry, 3 abrasive belt is in good condition, 4 governor oil level is normal, 5 fastening screws are tight sand, six infrared window and reflector is clean, whether 7 sanding machine belt tensioning, appropriate 8 check vacuum is normal, 9 grounding are in good condition, 10 compressed air adequacy of lubricating oil. Three, lubrication and swing. Four, tensioning abrasive belt and check whether the normal, abrasive belt installation direction is correct. Five, through to the main power supply, and check whether the brake disc is separated, it is strictly prohibited to lock. Six, start the main motor to check before sand swinging is normal, one at a time to start the main motor, waiting for * a main motor functioning and start the second motor, main motor starts to observe abrasive belt swing. Seven, before feeding oil standard caliper measuring the size of the workpiece, adjust the height can send belt according to measurement data to try sand, every time should not exceed 0 * sanding depth. 5 mm, sanding workpiece width is not more than 1 m. Eight, only sanding wood material, workpiece not contain metal, glass, hard and sharp material such as sand and gravel. Nine, sanding process often should pay attention to the machine running situation, if there is any abnormal must check, downtime in endanger personal safety, equipment safety, abrasive belt running deviation, abrasive belt collapse rotten emergency must use the emergency brake switch down, under the normal operation of the downtime don't use the emergency brake switch. Ten, prohibited to wear gloves operation, long hair women must wear a hat to hair in the cap. 11, when focused, cannot leave the machine, the machine run time can't touch the conveyor belt, prohibit skill in the machines, banned the runtime sand frame height adjustment. 12, the end of the work must be in the correct application downtime, dust clean inside and outside the machine, close all the power and compressed air, empty press side by side and the water in the machine oil and water separator.