Using and maintenance of CNC woodworking lathe tool tip

In use process, numerical control woodworking lathe tool is one of the most important part, so the use of cutting tool and the maintenance is very important, if you see here, maybe you will be in a hurry, why? Because in the numerical control woodworking machine working when you tend to ignore the problem is the tool, so you are worried about how food can know how to use tools correctly and safely. Then we can help you to solve such a problem. First of all, we want to say is the proper use of numerical control woodworking lathe tool steps which ones have. 1, mechanical equipment should have good performance, equipped with safety guards spindle swing and beating. 2, tool shank and jacket should be good contact, the handle must be fully inserted into the jacket, tightening and firm, clamping and found the handle when the handle diameter of contact trace uneven, or have groove, the description have slip case and jacketed inner hole deformation, clamp should be replaced immediately. 3, installation tools, make sure the cutting tool cutting direction with the main shaft running in the same direction, if in the opposite direction, will cause the blades split and other accidents. 4, paring knife must choose the appropriate size of the jacket, those who have the cross section, not enough round, worn and inner hole of a jacket with a taper is unable to provide enough clamping force, must be replaced immediately jacketed otherwise it will cause the handle vibration, fly off or break. 5 before, processing, make sure the machine no ahead, then idling, look for vibration machine, cutting tool for axial and radial run-out vision 6, when the cutting tool use is blunt, please do not continue to use, if continue processing, can increase the cutting force of blade, and thereby exceeding the capacity of the blade, tool rupture or producing operation accident. 6, when the cutting depth is greater than the edge cutting when the cutting thickness, the edge parts in contact with the workpiece can produce high temperature, tool steel body deformation, cause of cutting tool fracture, even work accident. Maintenance of CNC woodworking lathe to do it: 1, apply an appropriate amount of oil can prevent the tool surface rust and damage. 2, do not do STH without authorization, knife tools and change the configuration of the cutting tool, otherwise it is easy to cause of blade fracture, produce inductrial injury accident. 3, bearing cannot use diesel oil or kerosene solvent cleaning, otherwise it will damage the inside of the special grease, available blowing dust gun to remove dust and dirt. 2 -- 4 bearing each work After 3 hours, should add a little oil, this can prolong the service life of bearing. 5, not smooth rotating bearing needs to be changed immediately, the bad screw nut, screw, washer needs to be changed in time. 6, maintain the cleanness of the cutting tool, use standard industrial special solvents to remove dirt, wood, resin and other sundry. Knowledge of use of numerical control woodworking lathe tool are presented here, to the friends in need a little help.