Using numerical control woodworking lathe must pay attention to the inspection?

by:Gewinn     2020-03-25
Using numerical control woodworking lathe should pay attention to check the work to do, this is problem should pay attention to safety, avoid colliding and fly, the specific check details in the following paragraphs introduce in detail. Numerical control woodworking lathe is now one of the most common equipment in wood processing enterprises, it not only for enterprises to raise the working efficiency and economic benefit, and provides a great help to the development of wood industry. But in order to ensure its efficiency, in daily work to do a good job in checking then below small make up to introduce numerical control woodworking lathe routine inspection. 1, numerical control woodworking lathe when check belt firmness, should never put a finger between the belt and pulley, easily broken fingers. 2, check the motor, mechanical systems, etc. , make sure there are no abnormal noise. 3, check each part of the machine tool lubrication conditions. 4, check the cover and door and other safety protection device is safe and working properly. 5, check belt release, such as do not conform to the requirements of the specification, please adjust or change. The belt should be in good condition without damage. 6, the spindle before operation, collet chuck or knob should be tight, in case the collet chuck jaw left out or fly out. 1. The temperature of the machine tool in 6 7, temperature should be automatic operation of the machine tool state under no-load, at maximum speed machine tool movement binary machine running 10 to 20 minutes, or a third machine tool is made to reach a stable temperature. 8, in automatic operation, all the moving parts in machine tool to automatically according to the procedure, check all the moving parts of movement at the same time, should be smooth, no abnormal noise. 9, if the machine idle for a period of time, must be carried out on the machine tool operation temperature. To make the machine durable service life, stable and reliable accuracy. Today is to introduce the above routine inspection contents of numerical control woodworking lathe, hope to be of service.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...