Wood lathe lubrication machine maintenance requirements are what?

by:Gewinn     2020-04-26
Wood lathe is the main component is bearing, gear, guide rail and top, etc. If these parts, the phenomenon of the flexible use will affect the whole lathe, so do this a few parts of maintenance is very important. For the above we mentioned a few components are most in need of maintenance is lubrication. Good lubrication do woodworking lathe using life will increase, so we maintain to such a very necessary. Aiming at the particularity of wood lathe, lubrication also needs to have certain requirements, otherwise the beverage has the opposite effect, in the ensuing overshoot is close friends certainly good reading. Of wood lathe gear lubrication should pay attention to the main content of the impact and vibration of machine tool gear is not big, small load, and generally do not need to use an extreme pressure additives of lubricating oil. Need to be aware of how to prevent the spindle box of thermal deformation and impact load large stamping or shearing machine gear, gear oil containing anti-wear agent, should be used for circulation lubrication or oil bath lubrication of gear oil, in addition to consider the oxidation resistance, but also for corrosion resistance, wear-resistant, corrosion-resistant and anti-foam properties. Choosing the right gear oil according to the types of gear and suitable viscosity. Of wood lathe bearing lubrication should pay attention to the main items of the sliding bearing lubrication: sliding bearing is a common mode of transmission, lubricating oil is not only to play the role of lubrication and cooling effect, so you need to use of low viscosity lubricating oil lubrication performance is good, also need to have good oxidation resistance, abrasion resistance, rust and bubble resistance. Used for precision grinding machine spindle precision sliding bearing, bearing clearance by small ( 1 micron) , particularly high speed ( More than 30000 r/min) Viscosity should be used is very small, anti-wear oily excellent viscosity of 2. 0mm2( 40℃) The lubricating oil. Rolling bearing lubrication: rolling bearing on the machine, due to the advantages of small friction coefficient, and the advantages of quiet operation, and has been extensively used in machine tool, the rolling bearing inside diameter 25 mm, the speed of 30000 r/min, available grease seal in high speed. More than 30000 r/min, the application of forced lubrication or spray lubrication. Need to be aware of is the special case of rolling bearing in addition to the large, rough, generally cannot be used with solid lubricant grease. Perhaps this knowledge in your maintenance wood lathe is not enough, but this understanding after wood lathe has a lot of help.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...