Wood sanding machine how to operate

Wood sanding machine is a kind of woodworking machinery, many furniture production enterprise with woodworking sander, buying our products customers will often ask some questions about the mechanical operation, today we will post operation of woodworking sander out let everybody have a look. Communicate with each other. Operation of woodworking sander first need to understand you are coarse sand shall be thick or fine sand and sand with grain, choose different models of specific steps are as follows: a sand, start switch, two, start the conveyor belt, third, the measurement height, four, put the wood into the sanding machine, five, after the above five steps is measured with a caliper is sanding machine in the five main steps in the process of operation, the farther the specific is sanding machine safety operation procedures, broadband sanding machines must be professionals, prohibit others to operate. Second, broadband sander, first check before starting: 1, the machine have sundry; 2, whether sanding machine belt tensioning appropriate; 3, abrasive belt are in good condition; 4, governor oil level is normal; 5, fastening screws are tight sand frame; 6,, infrared window and reflector is clean; 7 voltage, air pressure is normal; 8, check the aspiration is normal; 9, grounding is good; 10, compressed air adequacy of lubricating oil. Three, prohibited to wear gloves operation, long hair women must wear a hat to hair in the cap. Four, tensioning abrasive belt and check whether the normal, abrasive belt installation direction is correct. Five, through to the main power supply, and check whether the brake disc is separated, it is strictly prohibited to lock. Six, lubrication and swing. Seven, start the main motor to check before sand swinging is normal, one at a time to start the main motor, waiting for the first main motor functioning and start the second motor, main motor starts to observe abrasive belt swing. Before eight, feed oil standard caliper measuring the size of the workpiece, adjust the height can send belt according to measurement data to try sand, maximum sanding depth every time can't more than 0. 5 mm, sanding workpiece width is not more than 1 m. Nine, can only be sanding wood material, workpiece not contain metal, glass, hard and sharp material such as sand and gravel. Ten, sanding process often should pay attention to the machine running situation, if there is any abnormal must check, downtime in endanger personal safety, equipment safety, abrasive belt running deviation, abrasive belt collapse rotten emergency must use the emergency brake switch down, under the normal operation of the downtime don't use the emergency brake switch. 11, broadband sanding machine operation concentration, cannot leave the machine, the machine must be able to operate without touching the conveyor belt, prohibit skill in the machines, banned the runtime sand frame height adjustment. 12, the end of the work must be in the correct application downtime, the broadband sander dust clean both inside and outside, close all the power and compressed air, empty press side by side and the water in the machine oil and water separator.