Wood sanding machine maintenance instructions

1 cleaning maintenance and protection of sanding machine. Reducer in the first three months in a reducer motor oil, oil change every homework 2000 hours later. For each activity parts should add grease once a month. 2. Shipped with not too tight. Or you will make delivery of shaft deformation craze, cut transportation with the use of the full 3. Machine should avoid direct sunlight or UV putty will dry solid in the coating on the wheel, so that the coating damage of wheel. 4. Such as coating damage faster, please will be bored with child into corrosions weak point, if using NC lacquer, please contact our company use another kind of raw material coated wheel. Sanding machine cleaning and maintenance to maintain the performance and efficiency of the machine, and regular cleaning and maintenance is not or lack of homework. Note: prior to the maintenance or repair work, it is necessary to close the main power supply. Does fixed period of cleaning: cleaning, daily cleaning, dust collecting tube and dust collecting cover. Use a hard brush and rags. Emissions, clean transport belt, air compressor of the water in the water filter. Using the lens cleaner and soft cotton swab. Near, cleaning machinery and accumulation of dust. Every week, cleaning table lifting screw and dust on the chain. Does protection and maintenance, security system start the machine, you must test all the safety switch is normal or not. Every week check and test the brake system, to prevent the 'emergency stop' can't fulfill. Main motor drive belt, appropriate adjustments will be added to the belt transmission power become old, yea, and apply the following to check the time see: first check: xinji have started to use or replace new second view: 4 hours after third view distance, one day after the previous view: from the previous view after 3 days, the fourth view: from the previous view, five days after the fifth view: 7 days after the previous view, view: after every other week advertent items: if the same pulley in a craze to replace, must replace hang together in the same other belt on the pulley. Sander was an expensive things, no matter about personal is still the company, this is a small items. Increase sanding machine using stature is a way to cut costs, woodworking machinery today will introduce our sanding machine maintenance and protection of some common sense, to advance the use of the machine life spans. 1. Reducer in the first three months in a reducer motor oil, oil change every homework 2000 hours later. For each activity parts should add grease once a month. 2. Such as coating damage faster, please will be bored with child into corrosions weak point, if using NC lacquer, please contact our company use another kind of raw material coated wheel. 3. Shipped with not too tight. Or you will make delivery of shaft deformation craze, cut transportation with the use of the full 4. Machine should avoid direct sunlight or UV putty will dry solid in the coating on the wheel, so that the coating damage of wheel.