loading

Woodworking machinery woodworking lathe safety operation procedures

by:Gewinn     2020-09-30

woodworking machinery, woodworking machinery, woodworking machine, sound-absorbing machine, woodworking machinery and equipment, woodworking equipment, sound-absorbing board equipment, wood edge banding machine, fully automatic sound-absorbing board machine, woodworking drill, side hole machine, CNC drill, side holes woodworking machines and woodworking cutting factory, woodworking drill, woodworking drilling equipment, automatic side hole machine, woodworking machine, furniture cutting machine, automatic cutting machine, woodworking machine equipment, precision cutting board saw woodworking machinery manufacturers woodworking equipment enterprises experience sharing of woodworking machinery woodworking lathe safety operation procedures:

, wood card, must turn the chuck by hand to correct, and check the tool holder and tool post top screw is rigid, then test power supply is connected;

, than mm long, processing must be used when the tailstock top top prison;

, cutting tools, tool rod stretched out the length of the tool carrier is shorter in mm. Keep the length of the mm tool rod. When processing a great work pieces ( Mm diameter above) Must be on the head with the cutting tool, cutting tool to clip, feed not too hard;

and small workpiece with a knot, no knife cut, the workpiece with a knot is not allowed to drive too fast, the wood have other hard things to keep clear of in time, otherwise no processing;

, turning with irregular edges and wood, should first part with fixed tool cutting edges, fine machining again with the car;

, turning the knife, feed quantity is smaller. With emery cloth and sand paper polishing, it must be right in front, left behind, the strength should be uniform,

wood, turning glue, must place hours rear can on a lathe processing;

, lathe speed according to the dimension and material of the machined part, not too fast, to prevent fly out of hurt;

and maintenance procedures:

every day, (1) the operator must be testing of the moving parts of a oil and clean;

(2) the mechanics for repairs to the transmission parts regularly.

double plane safety practices (BSPS)

all rotating parts and devices must be equipped with safety protection cover, correct use;

and closing or before starting, must inform the staff at attention, then closing boot, empty machine running a minute, no abnormal phenomenon can work, it is forbidden to take failure use;

and operation, it is strictly prohibited to a planing two pieces of different materials, specifications of the wood;

and maintain smooth feeding, such as found material walk cross or stuck, should reduce downtime mesa to take out the wood;

amount of planing, at a time should be mm, if hard wood, in addition to decrease planing should also reduce the feeding speed;

and feeding, must be advanced, and pay attention to prevent be dressed timber springback hurt at any time;

, be dressed timber length can not be shorter than before and after the roller center distance, when the plane is short of material must be continuous feed;

, replace the blade, the same blade on the cutter shaft and blade thickness and the weight of the lock screw must agree, pressure knife cut against must be cleaned and tighten the screw blade, the force should be uniform, shall not be too tight or too loose.

, scheduling, the feeding speed must be in operation scheduling;

not plane, processing of wood do not drop operation, so as not to damage the lifting gear;

, work has been completed, cut off the power switch, cleaning machine;

and maintenance procedures, the machine operators must every day to oiling machine elevator parts, clean and check the automatic injection system; Mechanics to filling equipment butter once a month, each quarter should make a comprehensive inspection for the machine.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...