What are the sanding machine safety operation specification?

Sanding machine is a kind of precision woodworking machinery. At the time of using it, we should strictly abide by the rules and regulations. Once appear, the wrong operation, is likely to result in the lagging of sanding machine fault and production. Next, we will discuss the safety operation rules of sanding machine. 1. After sanding mechanism of gear fault can't continue to use. 2. Operators must be familiar with the performance of the machine before operation, use and operating considerations, it is strictly prohibited to novice separate operation, unauthorized no boot without authorization. 3. Operators should wear overalls, gloves, the operator shall not be close to work the machine. 4. Before the start of check the conveyor belt and pulley between the diaphragm, demolition of clapboard and compressed air purge. 5. Check the belt drive reducer oil amount. 6. Check the three-phase 380 * 50 hz and the power supply is normal. 7. Open the main power supply control switch, switch on air and dedusting valve, to start the dust removal system. 8. Determine whether the belt is tightened correctly, compressed air pressure to zero. 5 Mpa, and close the door. At any time to ensure that the belt clean and sharp. 9. According to the requirements set data input button control panel. In order to run the sanding machine. 10. It is strictly prohibited in the sand table runtime to remove it. Must first stop, confirm the downtime, and then adjust the feed. 11. When machine running abnormal, should immediately stop and transfer of professional personnel, to ensure that the power disconnect in the repair process. 12. When they want to leave work, operators must shut down and stop chatting with others. 13. Avoid the belt part concentrated use, improve the utilization efficiency of belt. 14. Replace belt, the valves must be closed, and install belt movement direction arrow. 15. Banned for pull power forced crushed under the wheel of the workpiece. 16. When other abnormal condition, should immediately stop the maintenance. 17. Before coming off work, want to clean up machine and workplaces, clean up the dust around the machine, dust accumulated on the motor is forbidden, completes the routine maintenance of the equipment. 18. After work to shut down the vacuum valve, power supply, gas source and closed after the motor using control programs. 19. Keep the machine and the surrounding environment clean. 20. Every day to check brake motor. 21. Keep has plenty of oil mist and reducer. 22. Once every three months with butter. 23. Daily check of the sanding machine the air tube and valve, don't leak.