Woodworking sander coarse finishing system function and process

1, top and bottom of the pure components, motor power is zero. 75 kw, the motor voltage 220/380 v, the speed of 18000 r/min, cutter diameter 65 mm, chamfering R2mm, cutter tooth number 4. Woodworking sander coarse finishing system consists of a trimming and trimming of two parts, a knife for flat blade, second for circular knife, each cutter unit consists of the following parts, by copying wheel and small copying wheel guiding, artifacts will be made by milling cutter machining molding, pressure membrane will be milling and cutting tool will reverse processing. It get rid of the precipitation, copying wheel scraper must always against copying wheel. Five-star handle to make the adjustment in the different thickness of the edge sealing membrane institutions and the distance between the workpiece and the factory before placing thickness of 2 mm edge membrane, in the different thickness of the edge sealing membrane with membrane into to seal the side membrane can, without adjusting the five-star handle. 2, woodworking sander allow only qualified professionals operating machinery, comply with the general safety regulations. After turning off the main switch and high pressure air, to set up and replaced components, sharp knives can lead to injury, in time, open the silencing cover drive will be shut down, by electric motor brake quickly, when close the mute cover, gear will be reopened. Open again after the 30 seconds after the silencing cover closed, or you will fail, before the production begins, open the dust collection device. 3, the regulation of a trimming knife ( Tinker) In order to make secondary trimming ( The essence of trimming) Reduce the magnitude of the trimming cutting rounded corners, so as to get more smooth rounded corners, at the same time in order to meet the rounded, and the needs of the straight edge, the rough trimming mechanism. A trimming knife for flat blade, installation and debugging methods and secondary trimming knife installation method, is a straight line and horizontal trimming knife edge Angle of about 10 degrees. 4, the regulation of secondary trimming knife ( Refinement) When using the repair trimming mechanism of artifacts R rounded corners, simply on the trimming and trimming mechanism under several device Settings and the thickness of the sealing sideband relative to touch. 5, coarse finishing system error reason find cutter axis is not running check not open of the converter, the motor protection switch is triggered control defective hint, the SPS control machine is empty. Processing quality is not up to standard, cutter fixed, processing cutting tool not sharp, imbalance, check the profile wheel is, pollution or damage to the spring pressure is not enough, tool damage, etc.