Numerical control woodworking lathe and the reason of failure in the prevention of operation

by:Gewinn     2020-03-26
Numerical control woodworking lathe need to pay attention to some problems in operation, the operation of the special details and some of the fault processing, what are the specific reasons? The following detailed introduce you. Numerical control woodworking lathe is now mainly used in processing of wood processing industry equipment, numerical control woodworking lathe processing characteristics of high efficiency, cost savings for the enterprise to bring good economic benefits. But CNC woodworking lathe in the course of operation, there are many places need to be aware of, if not taken, will cause a certain loss, so we need to know some knowledge about its operation. Below small make up is to teach people how to prevent the numerical control woodworking lathe operating the fault. The causes of failure: 1, wood machinery and mechanical work knife shaft speed is high, the rotation inertia big, difficult to brake. The operator in order to make it as soon as possible after the machine stop stalling, often used to going to brake by hand or stick, often because of careless make hand and rotating cutter contact, causing hand-harm. 2, the operator is not familiar with the operation technology of woodworking machinery performance and safety, or not in accordance with the safety operation procedures, and no woodworking machinery equipment installation, safety protection device or safety protection device failure is easy to cause accident. 3, woodworking machinery, high speed, combined with the processed wood, in the process of cutting noise, vibration, workers labor intensity and fatigue. These factors are easy to make the operator error cause harm. Preventive measures: 1, woodworking machinery and equipment in use process, must ensure that the use of any tool in any cutting speed will not produce harmful vibration, when mounted on the knife shaft and shaft bearing high speed rotation, the axial clearance should be too big, so as to avoid operation risk. 2, woodworking machinery, with manual feeding, this is lurking on hands. When hand push into wood, because the knot, bending or other defects, unconsciously hand contact with the blade, cut or amputation. 3, all kinds of woodworking machinery and equipment shall be set up effective braking device, safety protection device and dust collection chip removal device. 4, knife shaft and electric interlock, lest hurt and replacement of cutting tools, get an electric shock the source button by mistake and make the tool rotation, cause harm. Above is the failure to the operation of the prevention of numerical control woodworking lathe simple introduced, welcome you to continue to stay in this web site for more details.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...