Numerical control woodworking lathe biaxial and double explanation

Everyone knows CNC woodworking lathe is used for machining equipment, wood cutting tool is an important part of a numerical control woodworking lathe. Whether tool to use the working efficiency and precision of the lathe. There was some kind of biaxial or double lathe market now, some people are not very understand what biaxial and double refers to, then below small make up to you to introduce the numerical control woodworking lathe were the biaxial and double refers to what. 1, double side of numerical control woodworking lathe center set can do the size of the party within 10 centimeters, so allow for faster processing of these columns, low jitter, good finish. The biaxial model due to the distance between the two axis numerical control woodworking lathe limit center set of size can only do side 6 cm long, side to side is greater than 6 cm, there is no center sets available. So the processing speed is slow, the effect is not good. 2, double adopt double layered when processing large pillar of wood turning, two knives on the axial distance there is a difference of 1 cm, we are always on the cutting depth according to the specified proportion into, so greatly reduce the cutting force of each knife. To avoid the vibration knife knife scar. ( Because mark is the most difficult grinding) And, since the two knives in the column of cutting force measurement for two columns, like beating of pillar greatly reduced, increased car wood finish. 3, a heightening of biaxial tool rest and heightening the spindle box on stability is reduced. Because the tool post, spindle box fulcrum in the following, the further away from the fulcrum turning to be the bad stability. 4, feeding the center: the center of the double stents using timber weight placed on a more natural state of decision center, the biaxial can only use a stent side, use hand to maintain state, so is not the same as the hands on the strength of will make the center of the column positioning, center location not will directly influence the processing effect. 5, due to the complexity of the biaxial loading and positioning are not allowed to be factors, such as the speed and effect of real, our experience is really as double fast ( Especially more than side 6 cm square columns from the center of their machining speed biaxial is slower than the us at least half though it is) 。 So we've seen a lot of use of biaxial lathes customers because of reasons of this bought actual use double spindle. The speed and effect of true. Still need to personally look at the compare in practical processing. Above is the two-axis CNC woodworking lathe and double introduced, hope to be of service.