Numerical control woodworking lathe programming considerations

When it comes to believe that are familiar with the CNC woodworking lathe, now it is the crystallization of science and technology, numerical control technology is the core of the lathe. But now a lot of friends on numerical control woodworking lathe programming is not very understanding, then below small make up to introduce numerical control woodworking lathe programming considerations. 1, numerical control woodworking lathe programming first paragraph must be as feed, equipment will not run this process. 2, the largest diameter shall prevail, hard wood feed amount shall not exceed 15 mm, soft wood feed amount shall not exceed 20 mm, easy cause large amount of feed device shake or damaged parts. 3, if timber machining allowance is too big, can use hierarchical processing way. 4, numerical control woodworking lathe programming should consider when equipment used by the clamp and the size of the thimble, if the size is smaller than chuck wood size, in the program to set free a wood, in case of damaged tools in the processing course. 5, the parameters of the 'shape' must not be set wrong, otherwise the program will go wrong. And in addition to the 'column' and 'empty shift' curve, its 'size' and this paragraph is allowed before the period of the 'size' of values are equal, the rest of the curve, 'path' in this section is not equal to 'size' of the value in the former period, otherwise the program will automatically stop. 6, a real 'diameter' of values for 'zero', if the value is 0, then the system automatically determine to complete processing. 7, to accurately measure, in case the samples do not tally with the workpiece shape. That is numerical control woodworking lathe programming note, hope to be of service.