Numerical control woodworking lathe routine maintenance
The use of numerical control woodworking lathe, caused a lot of convenience to our life, in order to ensure you use effect, avoid unnecessary loss, the next, small make up to you to introduce its routine inspection method, hope to help you. Routine inspection of CNC woodworking lathe when check belt firmness, should never put a finger between the belt and pulley, easily broken fingers. Check each part of the machine tool lubrication condition. Check the motor, mechanical system, make sure there are no abnormal noise. Check belt release, such as do not conform to the requirements of the specification, please adjust or change. The belt should be in good condition without damage. Spindle before operation, collet chuck or knob should be tight, in case the collet chuck jaw throw or fly out. Check whether the cover and door and other safety protection device is safe, working properly. Note that if the machine idle for a period of time, must be carried out on the machine tool operation temperature. To make the machine durable service life, stable and reliable accuracy. On the machine in automatic operation, all moving parts are automatically according to the procedure, and check the temperature of the machine tool in the motion of the moving parts should be automatic operation condition of the machine without load and at maximum speed machine tool movement binary machine running 10 to 20 minutes, or a third machine tool is made to reach a stable temperature. Above is the simple routine inspection of numerical control woodworking lathe is introduced, welcome you to continue to stay in this web site for more details.