Indonesia
Deutsch
boring machinery breaks the bottleneck.
Production backups caused by boring operations have led the carpenters to start looking for machinery manufacturers to help speed up production.
Products
Numerical control woodworking lathe storage method
by：Gewinn
2020-04-22
No matter what industry would have the off-season and busy season, except wood processing industry is not, of course.
When not take so much during the off-season CNC woodworking lathe usually sealed when the peak season when used at boot.
Here small make up teach you some numerical control woodworking lathe storage method.
1, before the seal up to the machine before all the machinery, electric equipment a clean dust removal operations, ensure the machine is in a clean and tidy condition under sequestration, slide for some, turning to the department for filling, in the device's bare parts surface coated with a layer of anti-rust oil, prevent rust, then covered a layer of protective film in the machine appearance.
2, the equipment is the most afraid of be affected with damp be affected with damp.
So for the equipment during storage must follow the time intervals of ten days or so to boot empty machine running for a period of time, with the help of running is the heat generated by the tide.
3, for equipment of power supply at the time of storage to cut off power supply, connect only when switched on, if not to start production only after completion of the trial run to unplug the power supply in a timely manner.
4, the machine's seal on the environment has certain requirements, shall be sealed in a dry, well ventilated environment, non-corrosive material factory.
Above is the storage method of numerical control woodworking lathe, hope can help to you.
Custom message
Related Products
