Numerical control woodworking machinery installation should pay attention to environmental problems?

by:Gewinn     2020-03-25
At the time of numerical control woodworking machinery installation should pay attention to the installation and use of the environment, the environment must conform to the requirements, specific environmental requirements? The following is introduced detailed. Numerical control woodworking machinery working environment temperature should be should be under taken in 40 degrees. In general, the numerical control electric cabinet with internal fan or cooling fan, to maintain the electronic components, especially the CPU working temperature or constant temperature difference is very small. When the temperature is too high will lead to lower control system component life, and leads to failure. Higher temperature, dust will lead to increased bonding in integrated circuit boards, and cause a short-circuit. Numerical control woodworking machinery used in the process of running, must pay attention to the working environment and conditions of use, only the reasonable use lathe, to play its actual performance, to a great extent improve efficiency, reduce the cost. Numerical control woodworking machinery location selection should be far away from the source of vibration, avoid direct sunlight, and the influence of thermal radiation, avoid the influence of humidity and airflow. Near the source, such as lathe, around the lathe should be set vibration ditch. Otherwise will directly affect the machining precision of lathe and its stability, easy to produce electronic components poor contact, failure, affect the reliability of the machine tool. Numerical control woodworking machinery in machining workshop, not only environmental temperature change is big, poor conditions of use, and a variety of mechanical and electrical equipment, power grid volatility. Therefore, the location of the numerical control woodworking lathe installation, need to have strict control on the power supply voltage. The power supply voltage fluctuation must be within the scope of the permit, and remained relatively stable. Otherwise it will affect the normal work of the CNC system.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...