Taiwan driller safety operation procedures

One, job preparation 1, will clean up machine mesa and workplaces; 2, check whether the bit is sharp, direction of rotation is correct, according to the requirements of processing adjust good crank rotating circle number; 3, commissioning, check whether the machine is normal; 4, ready to timber and accessories ( Plate, etc. ) 。 Second, the operating procedure 1, press the start switch, hand crank rotating, until the complete processing; 2, if the processing depth is larger, the press felt pressure, a handle and shake a few times, bit move up and down in the processing, the wood chips out; 3, homework, artifacts should be solid, not swing on both sides, so as not to break a bit; 4, each a kind of workpieces, must be first self-inspection; 5, first check whether the safety protection device is well before the work is complete, the bit clamping and firm, work is allowed to wear gloves and scarves. 6, according to the nature of the wood master appropriate drilling pressure and speed. 7, any product must have special fixed tool, may not be directly with the hand touch or hold down hole processing. 8, bit change, you have to stop, and may not use their hands and cotton material to touch the rotating parts. 9, drilling of sawdust, shall blow with the mouth, in case of flying into eye. 10, in exchange for workpiece, want to stop. The end of 11, homework, shut off the power, would clean wood chips, etc. Note 1, if the central axis loosening, vibration, or there are abnormal smell and sound, should be immediately shut down; 2, in the process of processing, clear in time processing of wood chips.