The maintenance of the woodworking machinery material frame

by:Gewinn     2020-09-25
Woodworking machinery material aircraft maintenance

a: each boot on the machine before you look into the inspection, see there is no damage to the machine or anomalies. Materials planes

2: the unpowered add butter spread to parts of lubrication, every month should add a main shaft bearing of butter, replaced once every six months reducer motor oil, engine oil plus 1/2 place between shaft and rod.

3: month check each connection point in electric cabinet can not have loose, in order to avoid burning appliances, affect the normal use, can not have oil and water into more.

4: use period, we should pay attention to the check of the bearing, the screw loose.

5: if you do not use, in the main shaft with butter, other easy rusty part to spray anti-rust oil.

6: if there is not automatic feeding, may be a loose time relay or burn out, notice the time relay delay must not be too short, should be adjusted for a long time, as far as possible so that we can reduce the frequent starting of motor and electrical damage.

7: period use if appear not turn after feeding, feeding and normal rotation, will check whether the drive belt is loose or belt wear, such as belt must be tighten loose reduction under the frame of four screws, has to be replaced a new belt wear.

material is mainly used for roll plate material uncoiling and winding. Can be either metallic materials or non-metallic materials. Woodworking machinery jin wing double material frame for the driving load automatically, this machine is the main features are: feeding is convenient, save time, scientific and reasonable structure, beautiful appearance, cover an area of an area small. Double material often match with leveling machine, automatic feeder automation equipment of stamping production line automation, high efficiency and energy saving, reduce cost and improve efficiency.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...