The problems encountered in the operation of numerical control woodworking lathe and the reason analysis
by:Gewinn
2020-04-20
Using numerical control woodworking lathe process will encounter some problems, we provide some possible reasons to solve these problems.
If you are using such problems in the process, you can according to these reasons are analyzed problems in this area.
If found the reason we can suit the remedy to the case quickly solve the problem.
Here we say part of the problem and may lead to main reason: 1, problem, numerical control lathe car out of the circular cone.
Before and after the reason is that the connection to the top with the spindle axis coaxial, is numerical control lathe to the rear of the center position is not right.
2, problem, numerical control lathe car round beating can not meet the requirements.
The reason might be the following points, respectively to examine at what time do the A.
Former top have with spindle axis misalignment or rotary's top bearing wear round to beat.
B。
Clean or central hole not touching workpiece center hole MAO.
C。
Touch the heart of central head of shifter lever chuck end face and make the center hole does not work.
3, the nc lathe turning workpiece vibration.
The reason may be that A.
The tailstock sleeve out too long or the workpiece is too loose.
B。
Tool is not sharp or tip arc is too large.
C。
Rotary's top bearing clearance of large or medium and small skateboarding gap is too big.
4, CNC lathe turning round to beat can not meet the requirements, the reason is that Ken can is A.
Former top have with spindle axis misalignment or rotary's top bearing wear round to beat.
B。
Clean or central hole not touching workpiece center hole MAO.
C。
Touch the heart of central head of shifter lever chuck end face and make the center hole does not work.
5, numerical control lathe center hole serious wear and tear or bite, it will be A.
Using a fixed top not add lubricant or spindle speed is too high.
B。
Lathe dog not clamping, rotates workpiece has stopped turning.
This is just part of the small make up to sort out problems in the numerical control woodworking lathe as well as part of the reason, if these problems and cause analysis for you when you need help, aetna will feel very honored, if you are the cause of the problem what supplements can contact with us we are looking forward to your opinions and ideas.
If you need other 2 analysis of the causes of the failure analysis can focus on the next.
Custom message
Related Products