The three numerical control woodworking machinery operation requirements

Numerical control woodworking machinery is the crystallization of science and technology, now is the main use of equipment, woodworking enterprises are widely used in industries. But numerical control woodworking machinery at the time of operation, should pay attention to many details, below small make up to introduce numerical control woodworking machinery operation of the three requirements. First of all, we are operating machinery and equipment, to check the mechanical equipment of various devices and the workpiece is normal. We should put the workpiece clamping and plunger top tight, then use both hands to turn the test run, after final confirmation of all normal, can drive a car. We will also according to the hard and soft wood parts, to choose suitable feed rate and rotational speed adjustment. Second, mechanical equipment in the process of turning, operators must not can use hand to touch to check the smoothness of the workpiece. When use sand paper burnish, should first after you remove will rest again. Machinery rotation, we must not can use the hand brake. In the end, we are processing of wood, if it is a square timber, we must first after processing into the shape of a cylinder with mechanical equipment for processing. If there is a knot in the wood, or there is a crack of wood, a certain cutting machinery and equipment cannot be used. Above is the numerical control woodworking machinery operation of the three requirements, can hope to be of help.