The use of numerical control woodworking lathe environment without any special requirements

In general, the use of numerical control woodworking lathe environment without any special requirements, can be the same as ordinary machine tools in the production workshop, however, want to avoid direct sunlight and other heat radiation, avoid too damp or dust in too many places, especially to avoid the places where corrosive gas. Corrosive gas is the most easy to make electronic components from corrosion deterioration, or cause poor contact, or cause a short circuit between components. Affect the normal operation of the machine tool. Stay away from big vibration equipment, such as punching, forging equipment, etc. For high precision numerical control woodworking lathe and vibration-proof measures should be taken, Such as vibration ditch, etc. ) 。 Numerical control woodworking lathe is don't have any special requirements on power supply, allowing fluctuations and 10% commonly, but due to the specific situation of the power supply in our country, not only the power band ( Sometimes far more than 10%) , and the quality is poor, there are some high frequency on the ac power often clutter signal, using the oscilloscope can be clearly observed that sometimes appear in large instantaneous disturbance signal, destroy the program or parameter of the numerical control system, influence the normal operation of the machine tool. Numerical control woodworking lathe to line power supply ( All the way from low voltage transformer room points for the use of numerical control woodworking lathe alone) Or adding voltage to curse, can reduce the power supply quality and reduce the influence of most electrical interference.