The use of woodworking trimming machine has finally been found

The edge trimming machine is to use the cutter head to edge the wood board. The edge of the wood board can be modified into a corresponding shape according to the shape of the cutter head. It is usually used as a right-angle rounded edge and is also used as a proper polishing operation for Wood. It is also widely applicable to the reinforcement of building beams, plates, columns, walls, etc. , decoration, wall installation, support, railings, billboards, air conditioning outdoor units, guide rails, satellite receiver elevators, steel structure factory buildings, etc. The trimming machine is generally operated with one hand, but in order to maintain stability and balance, it can be assisted by another hand. During operation, hold the edge trimming machine firmly first, and then turn on the switch of the edge trimming machine. When beginners just start to operate, they learn to be scared by the vibration and sound when the machine starts ( The first time I used KGS 254 M, I was shocked by the sound of the motor. When cutting aluminum profiles, my heart was always hanging) If you let go without holding the machine firmly, you will not only break the machine, but also be in danger. After the trimming machine is started, the machine will quickly reach the normal speed, and the milling cutter of the trimming machine can be inserted vertically into the working object. If you are in the trimming operation, the longitudinal saw machine, first stick the base to the working object below, and then slowly turn the milling cutter to the working object. At this time, you must hold the machine firmly to avoid rebound. After the milling cutter of the trimming machine is pressed into the working object, it can be pushed for milling. The speed of pushing will vary depending on the type of wood, milling depth, and blunt milling cutter. If you feel unable to push or the motor sounds heavy, you need to slow down. In the process of propulsion, the trimming machine should be kept stable and not tilted, otherwise milling will not be vertical. After the milling action is completed, the trimming machine can be lifted vertically to make the milling cutter leave the working object. If the edger is not lifted vertically, there will be a danger of breaking the milling cutter or breaking the work. If the trimming machine is operating, or the T-groove wire knife or flat feather knife is used, the milling cutter should be pushed to the right to leave the working object before lifting the trimming machine. After lifting the edge trimming machine, you can turn off the switch of the edge trimming machine and then place the edge trimming machine flat on the workbench. The tip of the milling cutter must face forward so as not to hurt oneself. If you want to use it again at intervals, you 'd better unplug it first.